While browsing through the Weaver Barn catalogue, Anita saw this cool looking arbor over a couple of doors. We decided that an arbor like this would look really nice over our side window.
To begin construction on the arbor, I grabbed some scrap cedar I had from building the shed and made about 24 slats. The slats were about 1 3/4″ wide by 13″ long with a little 1″ arch at one end.
Designing simply from a picture can be tough, so I grabbed a scrap piece of 6″ wide cedar, cut out a 4″ diameter arch and placed it around my corbel to see how to design the overall arbor.
The distance between the corbels is 6′ with the overall length of the arbor being 87″. I originally planned 25 slats about 3 1/2″ apart, but Anita thought it was a little too many slats.
We ended up deciding to use 21 slats 4″ apart. I wanted the slats to fit in place so I cut some dadoes in the wood to house the slats. Using my dovetail saw, router plane, and rasps, I easily cut the dadoes in no time.
I cut a small dado on each of the slats as well and test fitted the arbor together.
Since the slats had a dado, I decided the corbels should have dadoes as well to keep everything in line.
I also wanted the arbor to fit inside the corbels so I cut notches in both the front and back where the corbels would go.
I fit everything back together and drilled the slats to fit on the front and back. I used stainless steel screws so that they wouldn’t stain the arbor like galvanized screws would.
Dry fitting everything together the arbor started to come together nicely, so it was time to stain it.
I stained the arbor the same Benjamin Moore Cedar Bark stain we used on the shed.
However, after living with the color of the stain on the shed for a few weeks, we weren’t too happy with the color. So, after the first coat of Cedar Bark from Sherwin Williams, Anita mixed in a pint of Leather Saddle Brown with a touch of Fresh Brew stain from Benjamin Moore. Since all three stains were water based, they mixed together well.
After I applied the new coat, the cedar took on a much warmer color. We were very pleased.
Anita helped me install the arbor so I don’t have any pictures of it being installed as I wasn’t in the mood to tell her to hold onto the arbor while I stop and take some pictures. I started out measuring the length of the window frame and calculated how much on each end the corbels would need to be in order for the arbor to be in the middle of the window. The window frame was 67″ while the distance between the corbels was 72″. That left me with 2 1/2″ on each side of the window. I marked the spot and then decided how far above the window I wanted the arbor to be. Once I got that measurement, which was 2 1/2″ as well, I nailed the left corbel in place with 2 1/2″ galvanized pneumatic nails. Then, I placed the arbor on top of the corbel, leveled it, and then shot nails in the arbor itself, attaching it through the siding into the studs of the shed. I then screwed my stainless steel screws through my pocket holes attaching the arbor to the corbel to tighten everything up. Next, I took the right corbel and stuck it up into the recess of the arbor, nailed and screwed it up just as I did to the left one. Finally, I screwed and nailed the back side of the arbor to the shed.
As you can see, I think we made a good decision darkening the cedar stain. The cedar looks richer and blends better with the gray paint.
4 thoughts on “Building a Shed Part XII”
Looks fantastic! Nicely done.
Thanks. It’s taken me forever, but at least it’s getting done.
It’s a great looking piece Mike. Well done.